#Antonio zoli shotgun serial numbers serial numbers

Thickness for clearance to eliminate the chance of bumping the lower front of Some replacement cams may need to be fitted as to OAL & rear Opened gun hanging on this cam, as it needs to 'Bottom Out'. They should be long enough so they cock the gun but do not leave the

Pushes against the pushes against the cocking rods. At this timeД o not file much off the rear as this governs the overall length that You use a pin punch that will just fit the hole & drive the broken camДЇitting new cams, you may need to file the sides to fit a SNUG fit. Small round hole going almost all the way thru in the middle of the dovetailed #3403.92 COCKING ROD CAM -Дimensions are taken on the widest part of the dovetailed end. New style is a beefed up version in thickness and width. 287 wide) appears to be the earlier version. The old style cocking cam has a #1 stamped on top rear of the cam.

#Antonio zoli shotgun serial numbers serial numbers

Information is not available from the factory as to serial numbers The cocking rod cams are driven into a dovetail inДЄppear to be 2 different sizes as to width. Have not found any replacement mainspring that is strong enough. Gun by dragging the firing pin tip out of & across the fired primer. When the gun is opened, so that they do not interfere with the opening of the But these can't be too long in that they have to start to retract enough Somewhat converting the gun to non-rebounding hammers. If the above spacer still does not solve the problem, you can make firing Hammers are basically a rebounding type stopped by the cocking rods. Will still cock with the spacer installed. Will have to experiment with the thickness of this spacer to where the hammer Problem, then you can make a spacer to go behind the front threaded end to Of the mainspring is still applying at the point where the hammer is bottomed You can lengthen this unit (unthread it) so that the force Someone has had it apart & inadvertently threaded the plunger unit togetherД®nough to shorten it. Miss-firing is encountered, first look at the mainspring rebound to see if So that the upper part of the hammer has clearance when cocked. Units are made for RH & a LH in that they need to be installed on the pivot pin All that I have seen are the threaded together captivated unit. The parts drawing shows a non captivated unit. Plunger end (MS pilot) has changed from the factory parts drawing. Weak mainsprings this can lead to a miss-fire problem.

Upset when being seated, the primers are slightly desensitized & with the Also if reloads are being used & the primers happen to be The common thought is that firing pins are bad if miss-firing occurs. Illustrated parts breakout are ID numbers OR part numbers. GUNSMITHING THESE GUNS - It is not known whether these numbers shown on the above Who knows the assembly, with probably no one person or shop doing the complete Some shops may have made the barrels, others the receivers, Independent gunsmiths participated in this venture. As it was a 'Cottage Industry', in that MANY small Guns however, in reality were not all made by the same manufacturer. Made these pretty much on order and had very few spare parts So NO spare parts are available, as the 'factory' (sold under the Zoli name) were NOT the same.

Angelo has been out of business for MANY years & Antonio's guns, Not to be confused by his brother Antonio Zoli. These guns were made by Angelo Zoli of Italy & The author of this website DOES NOT have any parts.